Any 1" to 2" adaptors for 806 driver?

[stevenarrow]

Hello,

I am looking for an adaptor to mount standard 2" horn lenses onto Altec 806 two-bolt 1" exit compression driver.

Anything out there as a standard product?

[BillWojo]

I have 4 of them, brand new. 75.00 set of 2
Nice cast aluminum, the taper bore and flanges are nicely machined.

BillWojo

- - - Updated - - -

I just pulled them out of the box, the 1" side has 3 holes on a 4" diameter flange. The 2" side has a 4 hole bolt circle on a 4.7" diameter flange. The 4 holes are tapped and are on a 4" bolt circle. Overall length from flange to flange is 3"
It would be no problem to drill 2 holes on the 1" side for the Altec driver configuration. Of course I would do this on a Bridgeport milling machine to very close tolerances. (Ex toolmaker in another life)
Let me know if your interested.

BillWojo

[stevenarrow]

I have 4 of them, brand new. 75.00 set of 2
Nice cast aluminum, the taper bore and flanges are nicely machined.

BillWojo

- - - Updated - - -

I just pulled them out of the box, the 1" side has 3 holes on a 4" diameter flange. The 2" side has a 4 hole bolt circle on a 4.7" diameter flange. The 4 holes are tapped and are on a 4" bolt circle. Overall length from flange to flange is 3"
It would be no problem to drill 2 holes on the 1" side for the Altec driver configuration. Of course I would do this on a Bridgeport milling machine to very close tolerances. (Ex toolmaker in another life)
Let me know if your interested.

BillWojo

thanks for the offer that's great.

I ried to send a PM but I need a couple more posts here before I have those privileges. I'll get back to you very shortly.

[BillWojo]

No problem, I'm going to take all 4 of them to the shop and drill them to fit the Altec pattern. I'll gladly sell off 2 pieces but I think I'm going to hold onto the other 2, never know what I may find down the road.
I find the minimum posting requirements a pain but I just read other post and make comments on them. It gets you there pretty fast.
You can always e-mail me at Coyotebill57 at yahoo dot com.

BillWojo

[GM]

Do they match the 800's conical flare?

GM

[BillWojo]

Well, the flare is from 1" to 2" in a span of 3". Anyway, all 4 pieces have been drilled to the Altec mount. I drilled the holes exactly 1/4 inch so the drivers will line up closely. There is still the 3 hole bolt circle, possibly JBL mount?

BillWojo